Kitchenware daily maintenance can not be

Kitchenware daily maintenance can not be

With the improvement of living standards, people pay more and more attention to the quality of life. The most basic thing is to start from the maintenance of kitchenware.

Experts pointed out that there are many kitchens, including cabinets, electrical appliances, and hardware components. Different parts have different maintenance methods. Even the best products, daily maintenance can not be ignored. The three-point product is raised seven times. Let's take a look at how to maintain these kitchen utensils.

Because kitchen utensils always deal with water and fire, if you do not take good care of yourself, your lifespan will be shortened. In the maintenance of the kitchen counter, the weight should be placed under the kitchen counter. If water drops, it should be wiped dry with a dry cloth as soon as possible.

Sinks need to be leak-proof inside the table, if there is a leakage phenomenon to be repaired in time.

The maintenance of smoke exhaust stoves should be diligent, because oils and oils are just fried and the oil is hot. The oil stains are easily wiped off. Therefore, it is necessary to develop a good habit of wiping immediately after use. If the time is long, it will be difficult to clean.

If there is a water spot in the stainless steel sink, you can use a decontaminating powder or a scallop cloth to wash, and avoid heavy blows or sharp foreign objects damaging the surface. Paint utensils are used in the kitchen, and paint films are often peeled off, cracked, and scratched. To repair the falling paint film, use a spatula to scrape off the peeling paint, remove the moldy matter, and then polish the ground layer with sandpaper. Also pay attention to the primer and topcoat. Such a situation occurs in a room with high humidity.

In the kitchen, decorative components such as lacquer-coated kitchen furniture and bathroom door leaves are applied with paint to seal the six sides to prevent moisture. The cracking of the paint film is mainly caused by the excessive hardness of the paint on the surface layer. It should be polished off. Use a good paint with good flexibility to paint. Grasp the proportion of the curing agent, and do not apply too thick.

When the film is scratched very light, you can spray furniture care agent, wipe with a clean towel, scratches deeper, gently grinding with water and sandpaper and natural smooth with the surrounding, and then smear furniture care agent glazing. However, if the plan is very serious and there are spots of subsidence, the paint shall be applied in small portions until it finally drops flat.

Mill Cutter series

we are Mill Cutter series manfucturer and exporter, Pingyuan Best Machine tools Co., Ltd. product lines has covered more than 100 series, mainly include: CNC machine tool holders, collet chucks, collet sets, tool holder claw clamps, Tool Holder Tighting Fixture, spanners, Dust Chip Extraction Nut, tool holder pull stud and nuts, tool sensors, ATC tools library, boring head series etc. Our Tool holders include ISO, BT, NT, HSK, CAT etc series, we also accepted customers' customized parts and packages.

Mill Cutter Series ,Mill Cutter,Cnc Lathe With Mill Cutter Device Saw Bits,Mill Cutters For Cnc Lathe Machine

Pingyuan Best Machine Tools Co., Ltd. , https://www.jinancncroutertools.com